Post by dan on Sept 15, 2023 8:30:53 GMT -5
Hi there people!
I recently received a very damaged FG 312 II. Between some of the damages it has, there is the missing nut, that I have realized that is almost imposible to find out in that original measure.
After long time searching for a 45mm nut in 12 strings, I decided to order one of standard 49 and pray that I could sand it up in each side so it fits and the strings at sides are not too close to the neck border.
Do you know any other way of fixing it without ordering a customized nut?
Have anyone experienced similar situation?
The other big damage is that the previous owner seem to make a hole at the lower part of the front, probably would have installed any kind of jack connector for any reason....
Not sure yet if I might cover and paint or try to install that again ( I would need to figure out where to get that and how much that is)
ibb.co/X8s2ZfJ
ibb.co/sRskFm1
I recently received a very damaged FG 312 II. Between some of the damages it has, there is the missing nut, that I have realized that is almost imposible to find out in that original measure.
After long time searching for a 45mm nut in 12 strings, I decided to order one of standard 49 and pray that I could sand it up in each side so it fits and the strings at sides are not too close to the neck border.
Do you know any other way of fixing it without ordering a customized nut?
Have anyone experienced similar situation?
The other big damage is that the previous owner seem to make a hole at the lower part of the front, probably would have installed any kind of jack connector for any reason....
Not sure yet if I might cover and paint or try to install that again ( I would need to figure out where to get that and how much that is)
ibb.co/X8s2ZfJ
ibb.co/sRskFm1
